Brew Your Own Juice The Facts About Backup Generators

Brew Your Own Juice

 Blizzards. Ice Storms. Hurricanes. Floods. New Yorkers are used to being  buffeted by Mother Nature. But increasingly, it seems, the impact of such  storms has lingered long after the weather front blows through, with hundreds  or thousands or even millions of residents left in the dark. Beyond the inconvenience—the loss of modern-day necessities like television and air-conditioning—power outages can wreak havoc on condominium residents left in the dark.  According to the Eaton Corporation’s blackout tracker, last year in New York,10,918,400 residents were affected by  159 outages.  

 In times of emergency, like a power outage due to foul weather or a fire in the  building, certain aspects of many multifamily structures must function  properly; steps must be free and clear so people can use them, and doors to  stairways must function. In larger buildings, common areas, corridors and  elevators usually are illuminated through the power provided by an emergency  generator.  

 “Last year in the United States over 40 million people lost power and New York  City was hit particularly hard during Hurricane Irene. When Irene hit New York  City on August 28, power was knocked out for more than one million New Yorkers,” says Gary Moody of Silent Standby Power Supply LLC, a nationwide distributor of  battery powered generators. From August 20-29, 2011, Hurricane Irene barreled  through the Caribbean and the entire Eastern Seaboard, causing 56 deaths and  widespread destruction accounting for nearly $19 billion in damages.  

 “This is nothing new—power goes out all the time—but in the worst-case scenario of power outages, it can be life threatening.”  

 Some commercial high-rise buildings have backup power to service the elevators  when power goes out but it’s not required. Some larger New York City co-ops and condos, like Co-op City,  Penn South and North Shore Towers, have even installed co-generation plants and  have emergency power backup in case of an outage. However, according to the New  York City Department of Buildings, the building code doesn’t require residential buildings to have emergency power backup.  

 Powering Up

 There are two kinds of generators a building’s staff might use in a power outage: stationary sets or portable sets. A  portable generator could be used by the staff of the building during an  emergency or during construction work, if the structure does not have a  stationary set. Portable sets vary widely in quality, and can last anywhere  from four to ten years. The generating capability of stationary sets in  residential buildings can range from 60 kilowatts to 3,000 kilowatts.  

 “A building would want to maintain power to critical systems that would allow the  building to operate,” says Joe Cafiero of Control Electrical Contracting Corp. in Staten Island, “Such as elevators, public light and power, fire alarm system, PA systems,  intercom systems, HVAC, boilers and domestic water pumps or any other type of  pump for sewage and ground water.”  

 How long a generator lasts is partly dependent upon how much it is used and how  well it is maintained, adds Cafiero. “With the proper maintenance generators can operate reliably as long as any  vintage car. Some older generators can be re-built in place extending their  life indefinitely,” he says. “Generators should be tested during a regular schedule of maintenance.  Maintenance should occur at least bi-annually, if not quarterly. The generator  should be allowed to run quarterly and be tested under load annually.”  

 Testing the unit and running it will prevent the gas in it from going bad  prematurely, and will alert maintenance employees to any problems with the  machine. A couple of time per year, a manufacturer’s representative of the generator’s maker should come to the building and thoroughly test the generator.  

 If a generator with an automatic transfer switch is well-maintained, when the  lights go out it will turn on and provide emergency power to certain systems in  the building. Which systems it powers is a question of what is required, and  what residents want.  

 “Our systems can be operated in one of two ways,” says Moody, whose company manufactures a line of battery powered indoor  generators. “One way is to simply plug in an item or items into it and it doesn’t require any electrical to work. The other way is to have it wired into an  electrical panel and it will automatically turn on when the power goes out.  With our generators the batteries are the gas tank and they store the energy.”  

 How powerful the generator is that a building’s board picks for installation depends upon various factors—some legal, and others, lifestyle-based.  

 “On site generators will go on automatically under a blackout or power outage  condition,” says Cafiero, “But it might come on during a ‘brownout’ if the voltage dips below a voltage that is unsafe for equipment to operate at.”  

 Stationary emergency generators that are installed in multifamily buildings  typically are either diesel fuel powered units, or natural gas powered units.  Natural gas powered generators are connected by a line to the natural gas  utility’s system. Because of its reliability, natural gas is considered a 100 percent  (uninterruptable) power source for a generator, since the natural gas system is  rarely interrupted.  

 Diesel fuel powered generators need to have surplus fuel on-site in order to  operate. To be ready in the event of an emergency, the building’s staff also must have the generator gassed up. Usually a residential building’s generator will be used for no more than a few days at a time, meaning that  enough fuel to run it for that long will be stored on-site.  

 Stationary standby generators often are located in the basement of a building,  near the furnace room, in a room specifically created for the generator. In  other cases, these units are situated outside the building on a concrete pad,  near the transformer. Sometimes stationary generators are set up on a building’s roof, and in smaller buildings, the generator sometimes is located in the  garage.  

 A battery-powered indoor generator comes fully charged. The charge is stored in  a bank of batteries and available for immediate and easy use when you need it.  Everything plugged into the units outlets will be powered upon loss of power.  With battery-operated generators there is usually no gas, noise or fumes. These  battery systems will not run air conditioners in condos. Silent Standby Power’s Indoor Generator products retail from $3,000 to $7,500, depending on what  needs power and for what length of time.  

 Maintenance Required

 “Gas generators typically require more maintenance than battery-operated  generators,” says Moody. “With a battery-operated generator there are no moving parts.”  

 These emergency units do not need to be warmed up before reaching full capacity.  Larger, liquid-cooled generators usually have an engine block heater which  keeps the block warm and ready to go. Such generators automatically start if  the utility fails, and automatically switch off when utility power returns.  

 “Generators aren’t normally switched on. The conditions that cause the generator to operate are  usually dictated by the transfer switch that it is connected to,” says Cafiero. “The transfer switch is what switches the normal power source to the generator ‘emergency’ power source. When a power outage occurs a regularly maintained generator will  start and come up to running speed inside twenty seconds. Once the transfer  switch detects that the generator is producing a safe operating voltage the  power will be switched over and restored through the emergency power source.”  

 Professional Help

 Perhaps because generators are usually unseen and often unrecognized, the  absolute necessity of them is lost on some residents of multifamily buildings.  While keeping some of a high-rise building’s lights on and its elevators running during a power outage might seem to be a  convenience to some able-bodied people, disabled people and some elderly people  with mobility problems truly need the elevators to work so that they can get  out of the building safely. For some people, having an emergency system in  place can be a lifesaver.  

 Though installing a generator in a multifamily building can be a costly project,  it’s a solution some buildings choose to implement. The power generation needs  required of such a unit also usually are simple. That means in most cases, the  generator will be expected to provide power for common areas, garage doors and  elevators. Sometimes, a building’s generator also will provide power for heat, refrigerators and lights in the  structure’s apartments—but residents will pay a premium for the extras.  

 When planning to install an emergency generator in a residential building, the  building’s board members and staff must first ask the experts how to proceed. Usually,  this means hiring a consulting engineer or an architect to oversee the process,  beginning with a review of the building’s emergency power generation needs. Based upon that evaluation, the engineer  will determine how large the building’s generator should be. Next, the engineer designs the necessary transfer  switches for the generator, as well as a room in the building (or exterior/roof  space) in which to locate the generator.  

 The process includes the designer, as well as a general contractor, an  installing contractor, the co-op or condo board, the manufacturer, and the  local distributor who supplies the equipment. Usually, the design consultant  will offer to write up a Request for Proposals document (which describes the  parameters of the generator installation project), and distribute it to  electrical contractors so they can bid on the job. The board may hear the  consultant’s recommendation for which contractor to use for the job, and then the group  will vote and choose the contractor. That general contractor will ensure that  the installation project meets all safety requirements.  

 The laws that govern the use of generators in multifamily communities vary from  place to place. But questions regarding the generator’s operation can include where it will be placed, noise created by the unit, and  the storage of fuel (for diesel generators). Some local building codes require  a generator if a building is above a certain height (for elevators and fire  pumps, for example), while others do not.  

 The architect and installing contractor will work together to determine the  proper size generator, the type of generator and where it is placed. These  determinations could require analysis of the building’s roof structure, ventilation system, the concrete pad’s size and strength, the fuel source for the generator (gas lines or size of  diesel fuel tank), and the fresh air intake for the unit.  

 “The only dangers associated with having a generator is from the power source,” says Cafiero. “The natural gas or gasoline that powers the generator must be installed properly  in order to limit the risks. A well-maintained generator that is installed  properly and within code should operate safely and reliably for many years.”  

 Jonathan Barnes is a freelance writer and regular contributor to The Cooperator.  Staff Writer Christy Smith-Sloman contributed to this article.

 

Related Articles

Workers carry the window illustration. Vector colorful illustration of two male workers in gloves carefully carry the window for installation or replacement. Builders installing a window in the appartment

Window Maintenance & Replacement

Caring for a Crucial Building System

Work space field maintenance

Maintaining Your Elevators

Regular Care Can Help Avoid Huge Replacement Costs

Aerial photo site of the collapsed Champlain Towers South in 2021

The Champlain Towers South Collapse, Reconstructed

A Must-See for Boards, Managers, & Owners

 

Comments

  • Are there emergency generators for high rise water towers, specifically for flushing toilets? Can you use natural gas generators for this use?