Making a Smart Building Integrating Heating & Cooling Controls with Electrical Submetering

 Two research and development projects are currently underway in Manhattan where  the New York State Energy Research and Development Authority (NYSERDA), the  state agency that promotes energy efficiency, is supporting the development and  installation of groundbreaking smart air conditioners and heat pumps for smart  multifamily buildings. Both projects, one in an Upper West Side Mitchell-Lama  cooperative and one in a downtown all-electric multi-building cooperative  complex, integrate new smart air conditioners or heat pumps via an existing  advanced electrical submetering system to a smart building load management  system. These two projects have similar objectives: the development of  equipment that will improve energy efficiency, reduce electric bills and  provide the capability for participation in utility and state sponsored demand  response and curtailment programs. Demand response programs reduce the demand  on the Con Edison grid when necessary and offer buildings financial incentives  in return for their participation. Since the demand charge in master metered  buildings represents a significant component of the total electric bill, the  use of the smart air conditioners or heat pumps also provides each building the  ability to further reduce its demand charge. Demand response capability is  strongly advocated by both Con Edison and NYSERDA to provide a mechanism to  relieve the stress on the utility grid during high demand periods, thereby  reducing the likelihood of an interruption of power.  

 The Air Up There

 At Jefferson Towers (pictured), an Upper West Side cooperative located on  Columbus Avenue and 94th Street, approximately 230 through-the-wall smart air  conditioners were installed in 190 apartments. The new units are wirelessly  networked to the building’s existing submetering system that was installed in 2003. The smart air  conditioners are designed to permit building management to automatically reduce  the building’s peak electric demand in response to event days called by either Con Edison or  the New York State Independent System Operator (ISO) by issuing curtailment  commands to the smart air conditioners over the wireless communications  inherent in the building’s submetering system. Because master metered multifamily buildings pay for  electricity based not only on the number of kilowatt-hours (kWh) used in a  given month, but also based on its recorded peak demand (KW) this smart  building system can result in bill savings. The combination of a higher energy  efficiency ratio (EER) in the new air conditioners, demand reduction during  summer operation and incentive payments provides the building with an economic  benefit as well.  

 The Jefferson Towers smart air conditioners were recently installed and slated  to undergo testing and evaluation during the summer of 2011. When questioned  why Jefferson Towers agreed to participate in this project, Philip Olivetti,  president of the Board of Directors stated: “Like most buildings, we are always looking for ways to reduce costs and generate  revenue. The smart air conditioning system allows us to do both at the same  time, by improving energy efficiency and allowing us to participate in demand  response programs”.  

 At West Village Houses, an all-electric 42 building apartment complex containing  420 apartments, through-the-wall air conditioners are being replaced with a  networked system of smart heat pumps in four buildings served by a single Con  Edison master meter utilizing the identical advanced electrical submetering  system as installed in Jefferson Towers. The submetering system at West Village  Houses became operational in early 2010.  


Related Articles

Submetering for Savings

What Should Co-op & Condo Boards Know?

Securing Air Quality in the COVID-19 Era

HVAC, HEPA Filters, & UV Disinfection

Buildings to Receive Energy Efficiency Ratings

DOB, EPA Team Up to Issue 'Grades' from A to F